How to install windows xp using flash drive

You can use a USB drive to do the same. This will be required if we want to reinstall the OS. In order to install Windows XP from a flash drive, first you should dump your OS into this thumb drive. In order to do that, you will need. Plug in the USB flash drive and make sure you choose the following see image below before clicking the start button. Next you will need to start the command prompt. Check to verify the drive letter used by your USB flash drive. Let the utility do the needful.

Do not exit the Command Prompt yet. Press any key to continue and you will see a welcome screen with a menu appear in the Command Prompt. Now at this stage, you will have to insert the Windows XP installation disk into your optical drive.

A new popup will appear asking you to choose the location path of the Windows installation disk. If the motherboard in question happens to support a legacy BIOS mode, then it might work. Different version of Rufus explained later have better luck with the XP process than others.

We strongly suggest you skip to the dedicated part of this article that explains the problems with Windows XP and USB support. What about Windows Vista? But first…. Some solutions listed on this page require a Windows disc image.

ISOs are available from a number of sources, but most people will acquire them after purchasing the OS online through Microsoft, or through some other related Microsoft service. Only the ISOs directly supplied by Microsoft would have static hashes. How the image was captured as well will have an effect on how the final boot drive turns out, so stick to official sources where possible. Other tools exist that accomplish the same thing, but these are the only ones we can personally recommend.

However, we prefer Rufus because we find it loads a lot quicker, and feels a bit faster, too. For a great many reasons, this is still our preferred method of creating USB boot drives. To load the Windows. NOTE: As the program will state, doing this will erase all data off of the flash drive — so backup first.

If you have any issues, be sure to check out our Common Problems section below. NOTE: This method will delete the entire flash drive, so be sure to back up personal data first. Once selected, it needs to be wiped clean, have a partition created, and then be formatted. The entire command process is summed-up in this block:. At this point, the Windows setup DVD can be inserted into the drive, or the ISO mounted, and its files copied over to the root folder of the flash drive.

While the company no longer promotes the tool, it supports at least 7 and 8 just fine, so some might prefer to use it over the other solutions.

For example, try the following:. On your computer, disk 0 may not be the correct disk, you can use "list disk" to find the correct disk. With your drive all ready, you can now launch the Windows XP setup with a few custom parameters. Remember that all USB devices will need to be plugged in right from the start while using the rescue drive. Replace C: with the drive you want to install Windows to. Proceed with the installation. The setup program will then silently close, which might make you think that something went wrong.

Don't worry though. Note: The above guide works with Windows XP only. Buy Now. Contact US. Insert the USB drive you intend to boot from. Instructions for doing so vary wildly from system to system, but generally entail the following: Reboot the system. Go to the section that contains your boot devices. Be sure to read all the write-up first though. It will give you a step by step as to how to go through the installation. As for editing the windows installation. Try Nlite, its a free program.