Trv260 user manual

See page 82 for details. Unauthorized recording of such materials may be contrary to the copyright laws. These points are normal results of the manufacturing process and do not affect the recording in any way. Be careful when placing the camera near a window or outdoors. Doing so might cause your camcorder to malfunction. Take pictures of the sun only in low light conditions, such as at dusk.

LINK cable, be sure to insert the connector plug in the proper direction. If you insert the connector plug forcibly in the wrong direction, the terminal may be damaged. This may cause a malfunction of your camcorder.

Instructions with specific model names are for the indicated models only. Before you start reading this manual, check the model name of your camcorder.

Viewfinder LCD panel Battery pack. Before operating the unit, please read this. To prevent fire or shock hazard, do not.

This symbol is intended to alert the. For more information regarding recycling of. Caution: Do not handle damaged or leaking Lithium-. If you have any questions about this product, you may. The number below is for FCC related matters only. The model and serial numbers are located on the. Unleaded solder has the following characteristics.

Ordinary soldering irons can be used but the iron tip has to be applied to the solder joint for a slightly longer time. Soldering irons using a temperature regulator should be set to about Caution: The printed pattern copper foil may peel away if the heated tip is applied for too long, so be careful!

Unleaded solder is more viscous sticky, less prone to flow than ordinary solder so use caution not to let solder bridges occur such as on IC pins, etc. It is best to use only unleaded solder but unleaded solder may also be added to ordinary solder. Check the entire board surface for solder splashes and bridges. Check the interboard wiring to ensure that no wires are "pinched" or contact high-wattage resistors.

Look for unauthorized replacement parts, particularly transistors, that were installed during a previous repair. Point them out to the customer and recommend their replacement. Look for parts which, through functioning, show obvious signs of deterioration. Unleaded solder Boards requiring use of unleaded solder are printed with the lead- free mark LF indicating the solder contains no lead. Caution: Some printed circuit boards may not come printed with the lead free mark due to their particular size.

Ordinary soldering irons can be used but the iron tip has to be applied to the solder joint for a slightly longer time. Caution: The printed pattern copper foil may peel away if the heated tip is applied for too long, so be careful!

Do not insert the cable insufficiently nor crookedly. Cut and remove the part of gilt which comes off at the point.

Be careful or some pieces of gilt may be left inside When remove a connector, don't pull at wire of connector. It is possible that a wire is snapped. Digital8 video cassette. Gross: Approx. Average power consumption when using the battery pack. During camera recording using viewfinder 2. Design and specifications are subject to change without notice. Check the area of your repair for unsoldered or poorly-soldered connections. Check the entire board surface for solder splashes and bridges.

Check the interboard wiring to ensure that no wires are "pinched" or contact high-wattage resistors. Look for unauthorized replacement parts, particularly transistors, that were installed during a previous repair.